Home > Carbide End Mills > Carbide End Mills for Stainless 4 Flute AlTiN Coated Micro-grain Carbide 55HRC
Model: 4SSS-04025050-550Brand: APT Carbide End Mills
Shipped Weight: 25 g
Availability:
Only 7 left in stock - order soon
Carbide End Mills APT Brand
Carbide End Mill for Stainless 2.5mm Diameter 4mm Plain Shank 50mm Long 7mm Flute Length 4 Flutes AlTiN Coated
Also performs well on other materials up to 55HRC
Carbide End Mill for Stainless 1.5mm Diameter 4 Flute AlTiN Coated 55HRC£9.60 £6.40
Carbide End Mill for Stainless 4mm Diameter 4 Flute AlTiN Coated 55HRC£9.60 £6.40
Carbide End Mill for Stainless 5mm Diameter 4 Flute AlTiN Coated 55HRC£13.20 £8.80
High Perfromance Carbide End Mill for General Use 1.5mm Diameter 2 Flute AlTiN Coated 55HRC£7.50 £5.00
High Perfromance Carbide End Mill for General Use 1.5mm Diameter 4 Flute AlTiN Coated 55HRC£7.50 £5.00
High Perfromance Carbide End Mill for General Use 2.5mm Diameter 2 Flute AlTiN Coated 55HRC£7.50 £5.00
High Perfromance Carbide End Mill for General Use 2.5mm Diameter 4 Flute AlTiN Coated 55HRC£7.50 £5.00
High Perfromance Carbide End Mill for General Use 5mm Diameter 2 Flute AlTiN Coated 55HRC£10.50 £7.00
High Perfromance Carbide End Mill for General Use 5mm Diameter 4 Flute 75mm Long AlTiN Coated 55HRC£15.00 £10.00
High Perfromance Carbide End Mill for General Use 5mm Diameter 4 Flute AlTiN Coated 55HRC£10.50 £7.00
I used this cutter to machine a profile in 1.5mm stainless sheet.I set rpm to 9000, feed rate at 1mm/sec and cut depth to 0.1mm.Maybe I was being too cautious, but it cut ok with the occasional squirt of WD40.
Was this helpful to you? Yes / No
This review has not been appraised.
Very good product. Used on very hardened steel, no problem with high RPM.
